Reference number
ISO 15724:2001
International Standard
ISO 15724:2001
Metallic and other inorganic coatings — Electrochemical measurement of diffusible hydrogen in steels — Barnacle electrode method
Edition 1
2001-12
Preview
ISO 15724:2001
25688
No disponible en español
Publicado (Edición 1, 2001)
Esta publicación se revisó y confirmó por última vez en 2024. Por lo tanto, esta versión es la actual.

ISO 15724:2001

ISO 15724:2001
25688
Idioma
Formato
CHF 63
Convertir Franco suizo (CHF) a tu moneda

Resumen

This International Standard describes a method that uses an electronic hydrogen detection instrument for measuring

relative, diffusible hydrogen concentrations in bare steels or in plated steels after the coating has been removed. It is

assumed that the hydrogen is uniformly distributed throughout a part.

The method does not measure actual hydrogen concentration. However, oxidation current densities measured

against time provide a useful indication of relative hydrogen concentrations and, therefore, the measurements can be

used for comparison purposes. The method may be used as a quality control procedure as it does provide a quick

means of measuring the effectiveness of pre- and/or post-plating heat treatments or of monitoring hydrogen uptake

during plating or due to corrosion.

It is important to note that the absence of failure in a particular test does not provide confirmation of complete

elimination of hydrogen embrittlement because no one test method can provide all the data necessary to evaluate

the degree of hydrogen degradation.

For unplated parts the method is non-destructive; however, for plated parts the coating has to be removed prior to

measurement by a means proven not to damage the steel or to introduce hydrogen.

This test method is limited to:

— carbon and alloy steels, excluding austenitic stainless steels (see note 1);

— flat specimens to which the cell can be attached (see note 2);

— measurements at room temperature ( ).

NOTE 1 If this method is used for austenitic stainless steels and other face centred cubic (FCC) alloys, measurement times and

interpretation of results will have to be determined because of the different kinetics involved.

NOTE 2 For slightly curved surfaces it is essential to define an area that is reproducible. The area calculation will be different

from that described in this International Standard.

NOTE 3 The method can be applied to small parts, however, this necessitates some modification of the technique, procedure

and interpretation of results.

Informaciones generales

  •  : Publicado
     : 2001-12
    : Norma Internacional confirmada [90.93]
  •  : 1
     : 10
  • ISO/TC 107
    25.220.40 
  • RSS actualizaciones

Ciclo de vida

¿Tiene alguna duda?

Consulte nuestras Ayuda y asistencia