Reference number
ISO 15853:1999
International Standard
ISO 15853:1999
Thermoplastics materials — Preparation of tubular test pieces for the determination of the hydrostatic strength of materials used for injection moulding
Edition 1
1999-12
Preview
ISO 15853:1999
29282
No disponible en español
Publicado (Edición 1, 1999)
Esta publicación se revisó y confirmó por última vez en 2021. Por lo tanto, esta versión es la actual.

ISO 15853:1999

ISO 15853:1999
29282
Idioma
Formato
CHF 63
Convertir Franco suizo (CHF) a tu moneda

Resumen

This International Standard specifies a general procedure for the production, by injection-moulding, of tubular test

pieces for the determination of the resistance to internal pressure. It also specifies the design of the mould to be

used.

By using the same material as for injection-moulded piping components, such as fittings, these test pieces make it

possible to determine the time-related behaviour of the fitting material under hydrostatic pressure and under the

very same conditions as specified for extruded pipes. It is possible to test the resistance to internal pressure of the

injection-moulded tubular test pieces in accordance with ISO 1167, to extrapolate the results in accordance with a

method such as that specified in ISO 9080 in order to determine the MRS, and to classify the material in

accordance with ISO 12162.

The tubular test pieces also make it possible to verify individual points on previously established stress/time

regression curves as a minimum material test requirement.

The basis established by this International Standard allows test pieces to be prepared reproducibly.

Nevertheless, the method given is a general one, and the injection-moulding parameters have to be specified for

every material used.

NOTE If the compound used for the injection-moulding of piping components can also be extruded, then its time-related

behaviour may be investigated using either injection-moulded or extruded tubular test pieces.

Informaciones generales

  •  : Publicado
     : 1999-12
    : Norma Internacional confirmada [90.93]
  •  : 1
     : 7
  • ISO/TC 138/SC 5
  • RSS actualizaciones

Ciclo de vida

¿Tiene alguna duda?

Consulte nuestras Ayuda y asistencia