Reference number
ISO 16063-34:2019
International Standard
ISO 16063-34:2019
Methods for the calibration of vibration and shock transducers — Part 34: Testing of sensitivity at fixed temperatures
Edition 1
2019-12
Preview
ISO 16063-34:2019
71259
Indisponible en français
Publiée (Edition 1, 2019)

ISO 16063-34:2019

ISO 16063-34:2019
71259
Langue
Format
CHF 96
Convertir les francs suisses (CHF) dans une autre devise

Résumé

This document details specifications for the instrumentation and methods to be used for testing fixed temperature sensitivity of vibration transducers. It applies to rectilinear velocity and acceleration transducers.

The methods specified use both a comparison to a reference transducer and an absolute measurement by laser interferometer.

This document is applicable for a frequency range from 10 Hz to 3 kHz (method-dependent), a dynamic range from 1 m/s2 to 100 m/s2 (frequency-dependent) and a temperature range from ?190 °C to 800 °C (method-dependent). Although it is possible to achieve these ranges among all the described systems, generally each has limitations within them.

Method 1 (using a laser interferometer) is applicable to magnitude of sensitivity and phase calibration in the frequency range 10 Hz to 3 kHz at fixed temperatures (see Clause 7). Method 2 (using a reference transducer inside a chamber whose temperature limit is ?70 °C to 500 °C) can be used for magnitude of sensitivity and phase calibration in the frequency range 10 Hz to 1 kHz at fixed temperatures (see Clause 8). Method 3 (using a reference transducer outside the chamber) can only be used for the determination of the temperature response of complex sensitivity over a certain temperature range (see Clause 9).

NOTE Method 1 and Method 2 can provide the deviation of complex sensitivity over a certain temperature range if the calibration is also done at the reference temperature (room temperature 23 °C ± 5 °C).

To ensure the consistency of the use and test condition, the transducer, its cable and the conditioning amplifier are intended to be considered as a single unit and tested together.

Informations générales

  •  : Publiée
     : 2019-12
    : Norme internationale en cours d'examen systématique [90.20]
  •  : 1
  • ISO/TC 108
    17.160 
  • RSS mises à jour

Cycle de vie

Vous avez une question?

Consulter notre Aide et assistance