Status : Published (Under review)

This standard was last reviewed and confirmed in 2023. Therefore this version remains current.
Format Language
PDF
Paper
  • CHF129
Convert Swiss francs (CHF) to your currency

Abstract

This part of ISO 16063 specifies the instrumentation and procedures to be used for primary calibration of accelerometers using the reciprocity method and the SI system of units.

It is applicable to the calibration of rectilinear accelerometers over a frequency range of 40 Hz to 5 kHz and a frequency-dependent amplitude range of 10 m/s2 to 100 m/s 2 and is based on the use of the coil of an electrodynamic vibrator as the reciprocal transducer.

Calibration of the sensitivity of a transducer can be obtained using this part of ISO 16063 provided that the signal conditioner or amplifier used with the transducer during calibration has been adequately characterized. In order to achieve these measurement uncertainties, it has been assumed that the transducer has been calibrated in combination with its signal conditioner or amplifier (the combination of which in this part of ISO 16063 is referred to as the accelerometer).

Standard first page

Read sample 

Preview this standard in our Online Browsing Platform (OBP)

General information

  • Status
     : Published
    Publication date
     : 2002-04
    Stage
    : International Standard confirmed [90.93]
  • Edition
     : 1
    Number of pages
     : 20
  • Technical Committee :
    ISO/TC 108
    ICS :
    17.160 
  • RSS updates

Life cycle

Sustainable Development Goals

This standard contributes to the following Sustainable Development Goals

4
Quality Education
9
Industry, Innovation and Infrastructure

Got a question?

Check out our FAQs

Customer care
+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)

  2. Store
  3. Standards catalogue
  4. TC
  5. ISO/TC 108
  6. ISO 16063-12:2002