ISO 18119:2018
2018-05
Abstract
This document specifies the requirements for periodic inspection and testing to verify the integrity of cylinders and tubes to be re-introduced into service for a further period of time.
This document is applicable to seamless steel and seamless aluminium-alloy transportable gas cylinders (single or those that comprise a bundle) intended for compressed and liquefied gases under pressure, of water capacity from 0,5 l up to 150 l and to seamless steel and seamless aluminium-alloy transportable gas tubes (single or those that comprise a bundle) intended for compressed and liquefied gases under pressure, of water capacity greater than 150 l. It also applies, as far as practical, to cylinders of less than 0,5 l water capacity.
This document does not apply to the periodic inspection and maintenance of acetylene cylinders or to the periodic inspection and testing of composite cylinders.
NOTE Unless noted by exception, the use of the word "cylinder" in this document refers to both cylinders and tubes.
General information
-
Status: PublishedPublication date: 2018-05Stage: International Standard to be revised [90.92]
-
Edition: 1Number of pages: 55
-
Technical Committee :ISO/TC 58/SC 4ICS :23.020.35
- RSS updates
Amendments
Amendments are issued when it is found that new material may need to be added to an existing standardization document. They may also include editorial or technical corrections to be applied to the existing document.
Amendment 1
Edition 2021
Amendment 2
Edition 2024
Life cycle
-
Previously
-
Now
-
00
Preliminary
-
10
Proposal
-
20
Preparatory
-
30
Committee
-
40
Enquiry
-
50
Approval
-
60
Publication
-
90
Review
-
95
Withdrawal
Amendments
Provide additional content; available for purchase; not included in the text of the existing standard.PublishedISO 18119:2018/Amd 1:2021
PublishedISO 18119:2018/Amd 2:2024
-
00
-
Will be replaced by
Under developmentISO/AWI 18119
